emulsion phase
英 [ɪˈmʌlʃn feɪz]
美 [ɪˈmʌlʃn feɪz]
乳相；乳化相
双语例句
- The title alkyd resin modified waterborne nitrocellulose emulsion was prepared by alkyd resin phase inversion process.
采用醇酸树脂相反转乳化法制备了硝化纤维素乳液。 - High water-cut heavy oil W/ O emulsion to changed phase formation O/ W emulsion need lower the interfacial tension.
高含水稠油油包水乳状液转相成水包油乳状液，需要更低的界面张力。 - The title waterborne nitrocellulose emulsion was prepared with methods of phase inversion of alkyd resin and interpenetrating polymer network polymerization of acrylic monomers.
摘要采用醇酸树脂转相乳化法和丙烯酸酯类单体互穿聚合物网络聚合法制备改性硝化纤维素乳液。 - RESEARCH ON SYNTHESIS OF LAUROCAPRAM BY LIQUID-LIQUID PTC Preparation for Silicone Emulsion with the Phase Transition Method
液-液相转移催化法合成月桂氮？酮的工艺研究转相乳化法制备氨基硅油乳液的研究 - Preparation for Silicone Emulsion with the Phase Transition Method
转相乳化法制备氨基硅油乳液的研究 - In this paper, the basic theory and recent progress of emulsion phase inversion are summarized in detail.
本文总结了乳状液转相的基本理论和近年来的研究进展。 - Preparation of anionic silicone emulsion by phase inversion
相反转法制备有机硅阴离子乳液 - The result was shown that when the emulsifying water capacity below 60% the emulsion was W/ O type but when emulsifying water capacity over 60% the emulsion turned phase into O/ W type and the viscosity was lower with increase in the water.
结果表明，当乳化水用量小于60%时，乳液为W／O型；而大于60%时，转相为O／W型，且随含水量的增加，粘度减小。 - Comparing to the normal emulsion polymerization, the emulsion polymerization with phase inversion has higher polymerization rate, the polymer particle diameter is smaller and particle diameter distribution is narrower, the polymer emulsion has higher stability, especially when the solid content is high.
同常规的乳液聚合相比，伴有转相现象的乳液聚合有其自身的特点，转相使得聚合速率、聚合物粒径及分布、乳液稳定性等发生变化。 - With the extension of the residence time of emulsion phase on the surface, the efficiency of heat transfer decreases.
随着乳化相在表面停留时间的延长，乳化相与浸没表面间的换热系数减小，在接触时间较短时换热系数下降较快。 - By analyzing energy profile of different scale signals, we found that pressure fluctuations mainly reflect meso-scale interaction between the emulsion phase and the bubbling phase.
各尺度信号的能量分布表明，压力波动信号主要体现了介尺度的乳化相和气泡相之间的相互作用。 - The Gas Mass Exchange between the Jet and the Adjacent Emulsion Phase in the Grid Region of Fine Particle Fluidized Beds
细颗粒流化床分布板区射流与相邻乳化相的气体质交换 - In the research of W/ O petroleum ether emulsion system, the swelling and leakage of emulsion liquid membrane were studied, which was made by dispersing the emulsion into external phase twice.
对于W/O型乳状液体系，考察了石油醚乳状液的制备时各参数与稳定性能关系，研究了其二次分散能力，即形成W/O/W型液膜时的溶胀与泄漏情况。 - Concentration distribution in gas and solid as well as conversions were found in the bubble phase and emulsion phase at different time stages.
如此可解得不同时间时气体和固体的浓度分布和气泡相及乳化相中的转化率。 - The research results indicate: ( 1) The combustion of emulsion explosive matrix is a course of emulsion being destroyed, oil phase and water phase disjoining, water component vaporizing, organic matter carbonizing, then the system firing till reactant being consuming.
乳化炸药基质试样的燃烧过程是乳状液结构破坏、油水相分离、水分蒸发和有机物质碳化，然后系统发火，待反应物质消耗殆尽时，系统熄火。 - The preparation of high performance epoxy resin by emulsion dispersing phase transfer catalysis
乳液分散相转移催化合成高弹环氧 - The influence of U/ Umf on the radiative heat transfer between the surface and bubble phase and between the surface and emulsion phase is discussed in detail.
讨论了U/Umf对气泡相辐射换热和乳化相辐射换热的影响。 - Therefore, this article presents a study by way of core/ shell copolymerization and the seed for oneself to synthesize good tensile strength and high percentage elongation emulsion. The different phase structure of the hard-core inside and soft shell outside possess high elasticity.
本研究通过核/壳共聚，利用自生种子法合成出延伸率高、成本低、抗拉强度良好的高弹性苯丙乳液，形成内亲水、外疏水、内硬外软的异相结构。 - A Study of the Structure of Emulsion Phase and Stability of Bubbles in a Gas-Solid Fluidized Bed
气固流化床中乳化相的结构及气泡稳定性分析 - A nonionic surfactant and modified epoxy resin with cationic surfactant function have been prepared, which was used to prepare the waterborne epoxy emulsion by use of temperature phase inversion technology ( TPIT).
合成了非离子表面活性剂和具有阴离子表面活性剂功能的改性环氧树脂，采用温度转相法（TPIT）制备了水性环氧乳液。 - The paraffin emulsion was manufactured by surface-active phase ( B phase) emulsion process.
采用表面活性剂相（D相）乳化法，制备石蜡乳化液。 - First, the hydrophilic core was produced by means of concentrated emulsion which consists of the continuous phase of Span 80 and hexane and the dispersed phase of an aqueous solution of acrylamide ( AAM) and its crosslinker, N, N ′ methylenebisacrylamide ( MBA).
首先，由浓乳液（连续相为Span80的正己烷溶液，分散相为亲水性单体丙烯酰胺（AAM）及其交联剂N，N′-亚甲基双丙烯酰胺（MBA）的水溶液）制得亲水性核。 - Measurement of the Mass Transfer Resistance between W/ O emulsion and External Phase in Liquid Surfactant Membranes with an Improved Lewis Cell
采用Lewis槽对W/O乳状液与料液相界面间传质阻力的测定 - Simulation of the Dynamic Process of Heat Transfer between High-temperature Emulsion Phase and Immersed Surface
高温流化床乳化相与浸没表面间传热过程的数值模拟 - The high performance modified epoxy resin by furfural acetone was prepared by a novel method, emulsion dispersing phase transfer catalysis, by which the catalyst was dispersed well, the reaction system was difficult to agglomerate and the reaction was under control easily.
采用一种新的方法&乳液分散和相转移催化法合成了糠叉丙酮改性环氧。该方法使催化体系中的催化剂分散效果好，反应液不易结块，反应易于控制。 - The common processing methods of microspheres incorporate emulsion, phase separation, spray drying, electrospraying and so on.
微囊化的具体制备方法有乳液法、相分离法、喷雾干燥法、静电喷射法等。 - To increase the polarity and rubbing fastness, the pigments were surface-modified by emulsion polymerization and phase separation.
为改变有机颜料表面极性，提高颜料应用过程中的使用牢度，通过相分离法、乳液聚合法对有机颜料粉体进行表面改性。 - Based on the heat balance equation of each layer, we obtained emulsion phase temperature, bubble phase temperature and superficial bed temperature varying with height through Matlab. The simulation results of superficial bed temperature matched the industrial data well.
基于各子层内热量衡算方程，通过Matlab编程，模拟计算得到了乳化相温度、气泡相温度、表观床层温度随高度的变化曲线，表观床层温度与工业数据能够较好的吻合。